Starlight Tools

Boat Range and Reserve Fuel Calculator

Estimate reserve-adjusted range, cruise endurance, equal-conditions out-and-back distance, and planned-trip fuel margin. All inputs stay in this browser tab.

A fuel range estimate is not a passage planFuel burn and speed can change with wind, waves, current, load, trim, fouling, maneuvering, and engine condition. Verify actual usable fuel, vessel data, weather, tides, alternates, and applicable requirements before departure.

Fuel and cruise data

Fuel available

Enter measured fuel, not rated tank capacity. Onboard fuel, unusable fuel, and hourly burn must use the same selected volume unit, including the same gallon convention.

Fuel not safe to rely on because of pickup or tank limits.

Include all engines and continuous fuel consumers. Enter hourly burn in the selected fuel volume unit per hour, using the same gallon convention as onboard and unusable fuel.

Speed and reserve

Use the speed matching the entered burn rate. Through-water speed produces through-water range; speed over ground produces range over ground under the constant-speed assumption. The calculator does not calculate current corrections.

The 33.3% preset approximates a reserve of one-third of usable fuel.

Optional trip check

Use the entire intended route, including the return leg.

Inputs are processed only in your browser and are not added to analytics events.

Range and reserve result

Enter fuel, burn, speed, and reserve values to calculate.

Boat range formula

The calculator first removes unusable fuel and the selected reserve. The remaining travel fuel is divided by total hourly burn, then multiplied by speed.

Usable fuel = onboard fuel − unusable fuel

Travel fuel = usable fuel − reserve fuel

Range = travel fuel ÷ hourly burn × cruise speed

The out-and-back value divides reserve-adjusted range by two and assumes identical outbound and return conditions. It is not an allowance for current or weather. Planned-trip fuel = total route distance ÷ cruise speed × hourly burn. Use distance and speed units that match, such as nautical miles and knots, and the same reference for distance and speed. Margin above reserve = usable fuel − reserve fuel − planned-trip fuel. A negative margin means the modeled trip would consume some selected reserve or exceed usable fuel. A positive margin is only an arithmetic result under the stated assumptions; it does not establish route safety or reserve adequacy.

Percentage and time reserves

A percentage reserve holds back part of usable fuel. A time reserve holds enough fuel for the selected minutes at the entered cruise burn.

Percent reserve = usable fuel × (entered percentage ÷ 100)

Time reserve = hourly burn × reserve minutes ÷ 60

Do not treat a preset as universal. A suitable reserve depends on the vessel, passage, conditions, alternatives, applicable rules, and uncertainty in the inputs.

How to use this calculator

  1. Enter the fuel actually onboard and separately estimate fuel that cannot be relied on.
  2. Enter measured total burn at the intended cruise setting. If several engines or a generator are running, include all continuous consumption.
  3. Enter a realistic speed matching that burn. Prefer speed through water for a vessel-performance estimate; this produces through-water range. Entering speed over ground produces range over ground under the constant-speed assumption. The calculator does not calculate current corrections.
  4. Choose a percentage reserve or time at cruise burn. The one-third button sets a 33.3% holdback, approximating one-third of usable fuel.
  5. Optionally enter the complete planned route. Compare its fuel requirement and margin above reserve with a conservative passage plan.

Example range calculation

A boat has 120 US gallons onboard, of which 5 US gallons are treated as unusable, leaving 115 US gallons usable. With 12 US gallons/hour total burn, 18 knots through-water cruise speed, and a 33.3% reserve, reserved fuel is 115 × (33.3 ÷ 100) = 38.295 US gallons. Travel fuel is 115 − 38.295 = 76.705 US gallons. Dividing 76.705 by 12 gives approximately 6.39 hours of endurance. Use the unrounded values to calculate range.

76.705 US gallons ÷ 12 US gallons/hour × 18 knots = 115.0575 nautical miles, displayed as 115.06 nautical miles of through-water range.

Under the calculator's equal-conditions assumption, the corresponding out-and-back distance is 115.0575 ÷ 2 = 57.52875 nautical miles, displayed as 57.53 nautical miles for the outbound leg. This is through-water distance in this example, not necessarily distance over ground from the starting point. This is a math example, not a recommended destination distance. As a hypothetical illustration of the alternate time-reserve method, use the same 115 usable US gallons, 12 US gallons/hour burn, and 18 knots through-water speed, but select a 60-minute reserve instead of 33.3%. Reserved fuel is 12 × 60 ÷ 60 = 12 US gallons, leaving 103 US gallons for travel. Endurance is 103 ÷ 12, approximately 8.58 hours; range calculated from unrounded values is 103 ÷ 12 × 18 = 154.5 nautical miles through water. The 60-minute reserve illustrates the alternate method; it is not a recommended reserve.

Frequently asked questions

How is boat range calculated from fuel burn?

Subtract unusable fuel and reserve fuel from fuel onboard. Divide the remaining travel fuel by total hourly burn to get endurance, then multiply endurance by cruising speed.

What is the one-third fuel rule for boats?

The U.S. Coast Guard recreational boating guide describes using one-third of fuel to go out, one-third to return, and holding one-third in reserve. This is a general fuel-management practice, not proof that a particular passage is safe or compliant.

Should I enter rated tank capacity as fuel onboard?

No. Enter the fuel actually onboard. Use the unusable-fuel field for fuel that may not reach the pickup reliably because of tank shape, trim, heel, contamination, or vessel-specific limits.

Does this calculator account for current?

No. It uses the entered speed and fuel burn as constant values and does not calculate current corrections. Through-water speed produces through-water range; speed over ground produces range over ground under that constant-speed assumption. Knots specify a speed unit, not its reference. Current changes distance over ground, while wind, waves, load, fouling, maneuvering, and throttle changes can alter both speed and consumption.

Why is out-and-back range half of one-way range?

The calculator reserves half of the travel budget for the return leg. This simple division assumes the same route, burn, and effective speed both ways; real passages rarely have perfectly equal conditions.

Can I use maximum range as a destination distance?

No. Maximum range is a mathematical boundary under unchanged inputs. Keep appropriate additional margins and account for weather, tides, alternatives, vessel limits, and applicable requirements.

Are my boat fuel inputs uploaded or tracked?

No. Calculations run locally in the browser, and this tool does not send, store, or attach input values to analytics events.

Limits and safety disclaimer

  • The model assumes burn rate and speed remain constant. It does not model acceleration, idle time, detours, traffic, current, wind, sea state, fouling, load changes, or equipment faults.
  • Published tank capacity is not necessarily usable fuel. Pickup position, tank geometry, trim, heel, contamination, and gauge error can reduce available fuel.
  • The range reference follows the entered speed's reference, not its unit: through-water speed produces through-water distance, while speed over ground produces distance over ground under the constant-speed assumption. Knots can express either speed. The model does not calculate current corrections; through-water and ground distances can differ because of current.
  • The planned-trip check only compares arithmetic fuel demand with the selected holdback. It does not assess route safety or reserve adequacy.

Safety disclaimer: This educational estimate does not replace a passage plan, onboard fuel measurements, manufacturer guidance, official forecasts, navigation information, applicable regulations, or the judgment of the vessel operator.

Methodology and sources

Last reviewed: August 1, 2026. The model uses direct time, rate, distance, and volume relationships. Safety and unit guidance were checked against:

Explore more tools