Important planning note

This calculator is a budgeting and estimation aid, not a navigation, passage-planning, or safety system. Verify usable fuel onboard, required reserves, weather, sea state, currents, alternates, engine condition, and applicable regulations before departure.

How boat trip fuel is calculated

Boat fuel consumption is commonly tracked as gallons per hour or liters per hour at a known RPM and load. First calculate the expected running time, then multiply it by the combined burn rate of all engines. Use compatible distance and speed units: nautical miles with knots, or kilometers with kilometers per hour, give running time in hours. The multiplication below assumes the entered per-engine burn rate applies equally to each engine. A combined vessel burn rate already includes all engines and must not be multiplied by the engine count again.

Trip fuel = (distance ÷ speed) × burn per engine × engines

The calculator adds the selected percentage of expected trip burn to its “fuel with reserve” result: fuel with reserve = expected trip burn × (1 + r), where r is the selected percentage expressed as a decimal, so 20% means r = 0.20. Trip reserve is based on expected burn; the range calculation instead withholds a percentage of tank capacity. These calculations use different bases. The selected percentage is an allowance for the calculation, not a recommendation for a particular voyage.

Range and tank reserve

Range uses entered tank capacity after holding back the selected percentage of that capacity, then divides the remaining amount by combined hourly burn and multiplies by cruising speed. In the formula, r is the selected reserve percentage expressed as a decimal, so 20% means r = 0.20. Entered tank capacity is distinct from actual fuel onboard: a capacity-based result does not establish the vessel's current range when the tank is partly filled.

Range = entered tank capacity × (1 − r) ÷ combined hourly burn × cruising speed

Published tank capacity may exceed safely usable capacity. Pickup location, trim, heel, contamination, and tank shape can leave fuel unavailable to the engine. Unavailable fuel is distinct from the selected reserve, which is fuel deliberately held back. Subtracting a reserve percentage from tank capacity does not establish how much onboard fuel is actually available to the engine.

Example boat fuel calculation

For this illustrative example, assume one engine burns 12.4 US gallons per hour, fuel costs $5.25 per US gallon, and the selected trip reserve is 20%. The price and reserve are example assumptions, not a current price quote or a recommended reserve allowance. A 60-nautical-mile trip at 18 knots takes 60 ÷ 18 hours, or 3 hours 20 minutes. Expected consumption is (60 ÷ 18) × 12.4 = approximately 41.33 US gallons, costing $217.00. Adding 20% of expected consumption gives a fuel requirement including reserve of 49.60 US gallons and a fuel budget of $260.40. The budget includes fuel held in reserve; it does not mean all of that fuel is expected to be consumed. Calculations retain full precision until the final displayed results are rounded.

Frequently asked questions

Should I use GPH or MPG for a boat?

GPH is usually more useful because boat fuel burn changes sharply with RPM, hull resistance, load, wind, waves, and current. MPG or nautical miles per gallon can still help compare range at a known speed.

Where can I find my boat's fuel-burn rate?

Use a calibrated onboard fuel-flow instrument, measured fill-up records, or a manufacturer performance bulletin for the closest hull, engine, propeller, load, and RPM configuration.

How accurate is the horsepower estimate?

It is a rough wide-open-throttle benchmark based on generic fuel mass per horsepower-hour and fuel density. It cannot model hull efficiency, cruise RPM, propeller loading, engine technology, condition, or sea state.

Does the result account for wind and current?

No. Enter a conservative speed and measured burn that reflect the expected conditions, then evaluate additional contingencies separately.

Privacy and limitations

All calculations run locally in your browser. No route, vessel, cost, or fuel data is uploaded. Results are estimates and do not replace manufacturer documentation, onboard instruments, official requirements, or operator judgment.